Jump to content

Error at updating your program


bosho

Recommended Posts

Hello bosho,

Normally, a question like this would be posted in the General Malwarebytes' Anti-Malware section of the forum.

The error code 702 means there was an error expanding variables when you tried to run the program. Try following these steps and see if it fixes your problem.

  • Uninstall Malwarebytes' Anti-Malware using Add/Remove programs in the control panel.
  • Restart your computer (very important).
  • Download and run this utility. mbam-clean.exe
  • It will ask to restart your computer (please allow it to).
  • After the computer restarts, Temporarily disable your Anti-Virus and install the latest version of Malwarebytes' Anti-Malware from here
    Note: You will need to reactivate the program using the license you were sent
  • Launch the program and set the Protection and Registration. Then go to the UPDATE tab if not done during installation and check for updates.
  • Restart the computer again and verify that MBAM is in the task tray. Now setup any file exclusions as may be required in your Anti-Virus/Internet-Security/Firewall applications and restart your Anti-Virus/Internet-Security applications.

Hope this helps!

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
Back to top
×
×
  • Create New...

Important Information

This site uses cookies - We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.