Jump to content


Recommended Posts

As far as I can remember, I have always experienced the same problem, whichever version of MBAM I've used. Whenever Windows starts loading, if I don't wait long enough for the MBAM icon to appear in the systray and try opening anything, I'll get an error message and the MBAMService just stops. MBAM cannot be started until I restart that service and re-enable the Protection Module. Then, all is well.

Is this normal?

On a side note, I have already set exclusions for MBAM into my antivirus settings (NOD32) and I've even set a startup delay for MBAM in the registry. I did this 'cause if NOD32 doesn't have time to finish checking for updates and doing its usual startup scans (less than 30 seconds), MBAM will often crash. That's however settled.

Now, I have already uninstalled MBAM a few times with the special MBAM Cleanup tool you guys use. And, I've always installed the latest version.

I'm running MBAM Pro with Windows XP Pro.

Thanks in advanced. :)

Link to post
Share on other sites

  • Staff

Hello, welcome to the forums.

I'd like to run a diagnostic.

Download DDS and save it to your desktop from one of these links:



Double click dds.scr (or .com depending on which you’ve downloaded) to run the tool.

• When done, DDS will open two (2) logs

1. DDS.txt

2. Attach.txt

• Save both reports to your desktop, and attach both in reply.

Link to post
Share on other sites

This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
Back to top
  • Create New...

Important Information

This site uses cookies - We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.