Exploit protection off on startup

[Breach]

Hi,

Using the v3.0.6 of MBAM. I notice that exploit protection is always off on startup. I can then turn it on and it stays on... until the next reboot.

Any thing I can do about it?
 

Ta

[Telos]

Are you using CU3 (see Sticky posts)? If not, do so.

[Breach]

1 minute ago, Telos said:

Are you using CU3 (see Sticky posts)? If not, do so.

I have Component package version: 1.0.75, so I guess yes?

[Telos]

@Breach I'll let someone from MB address this then. Though the current advice seems to involved uninstalling (deactivate license before uninstalling), followed by the clean uninstall tool, followed by reinstalling CU3 from the sticky post. MB staff should be back in force tomorrow.Best of luck.

[Breach]

3 minutes ago, Telos said:

@Breach I'll let someone from MB address this then. Though the current advice seems to involved uninstalling (deactivate license before uninstalling), followed by the clean uninstall tool, followed by reinstalling CU3 from the sticky post. MB staff should be back in force tomorrow.Best of luck.

Thanks. I just reinstalled from the installer (on top of the existing version, without uninstalling first), rebooted and exploit protection was on. Weird, CU version before/after is the same. So seems fixed, but let's see...

[Phone Man]

I had the same problem after running MB-clean and new install.

I did the same over the top install and it worked great all day yesterday.

This morning on initial boot the problem was back except this time I could not get it to start.

I changed the startup option to delay for 15 sec and restarted and it looks good for now.

Here is my post from yesterday.

https://forums.malwarebytes.com/topic/197266-clean-install-of-3061469-1075/

Jim

 

 

 

Edited March 5, 2017 by Phone Man