MB Completes Showing 10 Treats ID'd 0 Quarantined

[RMT]

I may have had a Trojan that was dealt with by Norton Security Suite.  Next scanning with MB showed no threats while it was running, but on completion, it shows 10 threats identified and zero threats quarantined.  FRST files are attached below.  Any assistance is much appreciated.

Addition.txt

FRST.txt

[TwinHeadedEagle]

Hello and

 

Can you perform a MalwareBytes scan and then make a picture what was detected?

[RMT]

Thank you for your question.  It led to fixing an issue.  I was seeing that there were 10 threats, but not seeing what it detected, and that led me to post here.  I did check the Malwarebytes settings and found that there were PUP & PUM settings that prevented them from being brought to my attention.  I reset them and scanned as you suggested. Here is what it found:

The trojans that Norton removed were Trojan.Malteclcg1 and Trojan.Gen.  Do you believe that they may have changed the Malwarebytes settings?  I have now quarantined all of these items that were reported as non-malware, and believe that this matter is resolved.  Thanks for your help.  Do you agree that I should be OK now?

[RMT]

The image didn't insert in the message above.

Ten PUPs.docx

[TwinHeadedEagle]

Yes, you had some inactive threats. I don't think MalwareBytes settings can be changed by malware. What I was able to see, you don't have active infection, only these files in your temporary and downloads folders.

You're good to go now