Jump to content

Management console stuck simulating IP I didn't pick to simulate

Recommended Posts

Hi, first post. We recently installed Endpoint suite where I work and I'm pushing it out to our PCs by scanning the subnets and doing a client push.

This morning I picked 4 PCs out of a /24 scan IP range to simulate install, lets say -, 3, 5, and 6. I highlighted the four, right-clicked, and simulated push install. .1 and .3 passed, but now I'm seeing "Simulating" and the status icon is just spinning. It's been like this for about 20 minutes now. The other two still show "In queue for simulation".

I didn't pick .4, so why is it trying to simulate an install, and better yet, how to I stop it?

I saw something similar this morning on an install, and that's why I'm doing the simulation first. There was one "stuck" installing that required me to reboot the server to clear. I didn't remember seeing that IP in the "computers found" window either. Maybe this is the same issue?

Mbam ver:

Windows 2012R2 Server.



Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
Back to top
  • Create New...

Important Information

This site uses cookies - We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.