Jump to content

Application unable to open error(0xc0000142)[cmd.exe]


Recommended Posts

I am running a Windows 10 PC.

I get an error whenever I try to open command prompt," The application was unable to start correctly(0xc0000142).Click OK to close the application", I have posted about this error on Microsoft support. A member there asked to post about the error here, so as to ask you guy's if there might be any malware which is preventing cmd.exe from starting. It might be a possibility that a unknown program might be stopping it from starting. please help me with this.

Link to post
Share on other sites

Hello and welcome to Malwarebytes,

Please be aware the following P2P/Piracy Warning is a standard opening reply made here at Malwarebytes, we make no accusations but do make you aware of Forum Protocol....

If you're using Peer 2 Peer software such as uTorrent, BitTorrent or similar you must either fully uninstall them or completely disable them from running while being assisted here.Failure to remove or disable such software will result in your topic being closed and no further assistance being provided.If you have illegal/cracked software, cracks, keygens etc. on the system, please remove or uninstall them now and read the policy on Piracy.

Anyone other than the original starter of this thread please DO NOT follow the instructions and advice posted as replies here, my help and advice is NOT related to your system and will probably cause more harm than good...


Next,

Download Farbar Recovery Scan Tool and save it to your desktop.

Note: You need to run the version compatible with your system (32 bit or 64 bit). If you are not sure which version applies to your system download both of them and try to run them. Only one of them will run on your system, that will be the right version.

If your security alerts to FRST either, accept the alert or turn your security off to allow FRST to run. It is not malicious or infected in any way...
 
  • Double-click to run it. When the tool opens click Yes to disclaimer.(Windows 8/10 users will be prompted about Windows SmartScreen protection - click More information and Run.)
  • Make sure Addition.txt is checkmarked under "Optional scans"
  • Press Scan button to run the tool....
  • It will make a log (FRST.txt) in the same directory the tool is run. Please copy and paste it to your reply.
  • The tool will also make a log named (Addition.txt) Please attach those logs to your reply.

Post the two produced logs...

Thank you,

Kevin...

Link to post
Share on other sites

  • 2 months later...
Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
Back to top
×
×
  • Create New...

Important Information

This site uses cookies - We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.