Jump to content

MBAM scan will not finish


Recommended Posts

Please refer to this thread, which gives all the background :-

 

MBAM "Not responding"

 

The subject is explained and discussed quite thoroughly with some very helpful comments from advanced senior members.

 

The basic problem is that after 5-6 runs at different times and after several clean uninstalls and re-installs of MBAM, the scan runs perfectly well up to the Heuristics Analysis scan and then will not finish. I have to CANCEL and lose all the threats so far accumulated.

 

All my scans have been over 1.1/2 hours with 2.1/2 and 2.1/4 hours being the longest. The 3 files needed for examination have been sent and checked over, with no positive conclusion as to why this over-run is taking place.

1. CheckResults.txt
2. FRST.txt
3. Addition.txt

 

I was advised to place the problem on this section.

Hope you can help.

Link to post
Share on other sites

  • 4 weeks later...
  • Staff

Due to the lack of feedback this topic is closed to prevent others from posting here. If you need this topic reopened, please send a Private Message to any one of the moderating team members. Please include a link to this thread with your request. This applies only to the originator of this thread.

Other members who need assistance please start your own topic in a new thread. Thanks!

Link to post
Share on other sites

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    • No registered users viewing this page.
Back to top
×
×
  • Create New...

Important Information

This site uses cookies - We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.