Jump to content

Recommended Posts

I am running windows 7 on a desktop computer. I did have a virus and ran an old Malwarebytes with an old data that I had and it seemed to remove most of the virus. When I went to update data file I was told there was a new version of Malwarebytes, it unloaded the old version and went to load the new version. I get through all the propts and almost to the end of the install process where it says "Access Denied", then "setup was not completed. Please correct the problem and run Setup again" it then rolls back the changes and doesnt install. Any help would be appreciated.

Link to post
Share on other sites

Hello and welcome to Malwarebytes

If you are installing under a limited account that would explain the error. Try installing/running Malwarebytes as and admin user. It could also be the infection you have that may be causing the issue. Please follow the instructions below to get you cleaned up.

Since you are/were infected, here are the steps needed to get your computer cleaned....

Please read the following so that you can begin the cleaning process:

Don't use any temporary file cleaners unless requested - this can cause data loss and make recovery difficult

You have 3 Options that you can choose from as listed below:


  • Option 1 —— Free Expert advice in the Malware Removal Forum
  • Option 2 —— Paying customer -- Contact Support via email
  • Option 3 —— Premium, Fee-Based Support

OPTION 1

As we don't deal with malware removal in the
General Malwarebytes' Anti-Malware Forum
, you need to start a topic in the

Malware Removal forum
so a qualified helper can help you fix any malware related problems/infections you may have.


  • Please read and follow the
    , skipping any steps you are unable to complete.

  • After posting your new post, make sure under
    options
    , you select
    Track this topic
    and choose
    Immediate Email Notification
    ,

    so that you're alerted when someone has replied to your post.

NOTE:
Please do not post back to (bump) your topic within the first 48 hours.

Replying to your own posts changes the post count and helpers are looking for topics with zero replies.

If you reply to your own post helpers may think that you're already being helped and thus overlook your post.

    • If there is no reply from any experts after 48 hours, you can reply to the topic, asking for help again.

      Or

    • You may send a Private Message to a Moderator asking for assistance.


OPTION 2

Alternatively, as a paying customer, you can contact the help desk at
or
.

OPTION 3

If you would like to use our
Malwarebytes Premium Services
, Comprehensive solutions to all your computer support needs—from installation and set-up to troubleshooting and tune-ups go to our
support site.

Please be patient, someone will assist you as soon as possible.

PS: Please use the "Add Reply" Add-Reply.png button not the Reply button when you start replying.

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
  • Recently Browsing   0 members

    • No registered users viewing this page.
Back to top
×
×
  • Create New...

Important Information

This site uses cookies - We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.