fivealive Posted December 30, 2011 ID:511236 Share Posted December 30, 2011 so when 1.6 came out it updated no problem ran perfectly but when i reboot the computer the next time mbam didnt come on right away it was set t odelayed start so i recall having to fix that ( i have windows 7) so i followed the directions to fix that and figured that was the end of the issue well a couple hours later i turned teh computer off and i just turned it on about 10 minutes ago and it was doing the same thing delayed start no idea why went back into the menu to change it to automatic but i dont know if it will stay that wa y Link to post Share on other sites More sharing options...
exile360 Posted December 30, 2011 ID:511237 Share Posted December 30, 2011 so when 1.6 came out it updated no problem ran perfectly but when i reboot the computer the next time mbam didnt come on right away it was set t odelayed start so i recall having to fix that ( i have windows 7) so i followed the directions to fix that and figured that was the end of the issue well a couple hours later i turned teh computer off and i just turned it on about 10 minutes ago and it was doing the same thing delayed start no idea why went back into the menu to change it to automatic but i dont know if it will stay that wa yAfter the first reboot after installation, it will be reset, but should be retained after that until you do either of the following:Exit the protection module and then enable it again (this resets the service startup to delayed)Access the Scheduler (this resets the service startup to delayed)As long as you don't do either of those, it will remain set to Automatic without the delay. Link to post Share on other sites More sharing options...
fivealive Posted December 30, 2011 Author ID:511238 Share Posted December 30, 2011 hmm then i might have been the scheduler that did it i recall going in there to make sure that all scheduled stuff was saved thank you for your prompt answer Link to post Share on other sites More sharing options...
exile360 Posted December 30, 2011 ID:511362 Share Posted December 30, 2011 You're welcome Link to post Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now